Compact, Slim Dimensions, Waterproof Digital Transceiver

dPMR™ Mode 1/2 Operation

The IC-F1000D/F2000D provides dPMR digital Modes 1, 2 as well as analogue operation. dPMR digital mode offers 6.25kHz spectrum efficiency, higher security and greater audio clarity even on the fringes of the communication range.

The following dPMR features are programmable:

  • Remote kill, stun and revive (RX)
  • Ambience listening
  • Status Call (TX and RX beep)
  • SDM (Short Data Message) (RX, notification only)
  • Voting scan for multi-site conventional operation
  • GPS position data (TX) with optional GPS microphone, HM-171GPW

TX: Transmit, RX: Receive

Intelligent Emergency Functions

To assist in worker safety, the IC-F1000D/F2000D has four emergency related functions: motion detection, stationary detection, man down and lone worker functions. If one of these functions are activated, the transceiver automatically enters an emergency phase and starts counting down to send an emergency signal. The acceleration sensor sensitivity level is programmable in 10-levels for each function.

Optional GPS Speaker-Microphone

With the optional GPS speaker-microphone, HM-171GPW, GPS position data can be attached to a voice or data transmission such as responding a GPS request status call.

IP67 Waterproof and Dust-tight Protection

While the body is compact, the IC-F1000D/ F2000D has rugged construction providing superior protection against water (1m depth for 30 minutes), dust, sand, mud and other objects. The radio is also tested to MIL-STD 810 specifications. It can withstand harsh use.

Slim, Compact and Lightweight

The IC-F1000D/F2000D has a compact 52.2×111.8×30.3mm body and weighs only 260g (with BP-280 battery pack and belt clip). It's easy to carry around anywhere.

Long-Lasting Battery Pack

The large capacity waterproof battery pack, BP-280 (2400mAh typ.), provides 18 hours of operating time*. The supplied rapid charger BC-213* charges the BP-280 in 3.5 hours.
* Tx: Rx: Standby=5:5:90. Power save function ON. BC-213 may be not supplied depending on version.

Easy to Hear in a Noisy Environment

The large 36mm speaker of the transceiver provides clear 800mW* audio. The built-in BTL amplifier increases the audio output power and delivers loud and intelligible voice to a radio operator working in noisy environments.
* Typical with internal speaker.

Built-in 2-Tone and 5-Tone (Analogue mode)

The IC-F1000D/F2000D has built-in 2-Tone, 5-Tone, CTCSS and DTCS signaling capability for analogue mode group communication and selective calling. The IC-F1000D/F2000D can be used as an analogue transceiver ready for future digital migration.

Other Features

  • DTMF autodial memories
  • BIIS PTT ID call and emergency call
  • Surveillance function
  • Escalating alarm
  • VOX capability for hands-free operation
  • Channel announcement function
  • Red emergency switch on the top panel

Icom Inc. issued this content on 28 January 2016 and is solely responsible for the information contained herein. Distributed by Public, unedited and unaltered, on 28 January 2016 08:54:25 UTC

Original Document: http://www.icom.co.jp/world/products/land_mobile/handheld/ic-f1000d_eur_dpmr/